Call Hold And Transfer; Call Holding - Toshiba Perception e&ex User Manual

DIGITAL TELEPHONE
To Park a Call:
1. Press the PARK button, or
press the CONF/TRNS
and dial the access code
_____.
2. Hang up or dial another call.
To Reconnect a Parked Call:
1A. Lift the handset.
... or ...
1B. Press the DN button (this is
necessary only for calls which
are parked on a DN other than
the primary DN).
2A. Press the PARK button or dial
the access code (* * 3) _____.
To Hold a Call:
1. Press the HOLD button.
2. Hang up.
18

CALL HOLD AND TRANSFER

CALL HOLDING

Call Park and Call Hold are two methods of holding calls. The Call Park
(PARK) button allows you to originate and receive calls on the
once the call was parked (on hold). If you do not return to the parked call
within a designated time period, your telephone will ring to recall you.
The Call Hold (HOLD) button causes the
a held call will not recall you.
The PARK LED will light (only if the
button
LED will indicate the In-use status (unchanged). The Park connection will
(* 3))
be placed on hold, and you will hear dial tone.
The primary DN LED will indicate the In-use status, and you will hear dial
tone.
The DN LED will indicate the In-use status, and you will hear dial tone.
The PARK LED will go out, you will no longer hear dial tone, and you will
be reconnected. The primary DN LED will indicate the In-use status
(unchanged).
The DN LED will change from In-use to On-hold status, and the
connection will be placed On-hold.
PERCEPTION e
DN
DN button to become busy, but
PARK button is equipped). The DN
ex
&
button