Toneralert Level - Kyocera ECOSYS P2135dn Operation Manual

>TonerAlert Level
ID
_
Password
_
Using the Operation Panel
TonerAlert Level (Setting for the alert level for toner
addition)
This sets the toner addition alert level displayed on the status monitor.
The options available in TonerAlert Level are as follows:
• ID (Administrator ID input)
• Password (Administrator Password input)
• Off/On
• TonerAlert Level (Setting for the alert level for toner addition)
1
Press  while Device Common > is displayed.
2
Press  or  repeatedly until >TonerAlert Level > appears.
>
ID (Administrator ID input)
To use the TonerAlert Level settings, you must enter an administrator ID.
For information on how to set the administrator ID, refer to
Administrator (Administrator settings) on page 7-81.
1
Press  while >TonerAlert Level > is displayed.
2
The message display shows ID and a blinking cursor (_).
3
Press  or  to increase or decrease, respectively, the value at the
blinking cursor. Enter the specified ID. Use  and  to move the
cursor right and left. Enter an ID consisting of between 1 and 16
numbers.
4
Press [OK]. Proceed to the next step Password (Administrator
Password input).
Password (Administrator Password input)
To set up the TonerAlert Level settings, you must enter an administrator
ID and administrator password. For information on how to set the
administrator password, refer to Administrator (Administrator
settings) on page 7-81.
1
Once you have entered the correct ID in the previous step (ID
(Administrator ID input)), the message display shows Password
(Administrator password input) and a blinking cursor (_).
2
Press  or  to increase or decrease, respectively, the value at the
blinking cursor. Enter the specified password. Use  and  to move
the cursor right and left. Enter a password consisting of between 0 (no
settings) and 16 numbers.
Note If you enter the incorrect administrator ID or password,
the message Wrong ID or Wrong Password appears and
the input screen then reappears. Re-enter the ID or password
correctly.
3
Press [OK]. The TonerAlert Level settings screen appears.
7-71