Kyocera ECOSYS P2135dn Operation Manual page 158

>AppleTalk
? On
>IPSec
? Off
7-52
AppleTalk (AppleTalk setting)
AppleTalk is a communications protocol used primarily on Macintosh
computers and also refers to the Mac OS network functions.
AppleTalk assigns 24-bit network addresses (a 16-bit network section
and an 8-bit node address) that are used to identify devices (computers,
printers, etc.) on the network.
When the power is turned on, a broadcast signal is sent out onto the
network and the addresses and machine names are automatically
assigned. The default setting is On.
1
After entering the administrator ID and password, press  or 
repeatedly until >AppleTalk appears.
2
Press [OK]. A blinking question mark (?) appears.
3
Press  or  to select whether AppleTalk is enabled.
4
Press [OK].
5
Press [MENU]. The display returns to Ready.
IPSec (IPSec setting)
IPSec (IP Security Protocol) is a security protocol adopted as the
standard by the IETF for authentication and encryption in the third
network layer (IP layer).
It can be used with both IPv4 and IPv6.
Note IPv4 uses 32-bit IP addresses and IPv6 uses 128-bit IP
addresses.
1
After entering the administrator ID and password, press  or 
repeatedly until >IPSec appears.
2
Press [OK]. A blinking question mark (?) appears.
3
Press  or  to select whether IPSec is enabled.
4
Press [OK].
5
Press [MENU]. The display returns to Ready.
LAN Interface (LAN Interface setting)
Specify the settings for the LAN interface to be used. The default setting
is Auto.
Note LAN Interface is only displayed when the optional network
interface kit (IB-50) is installed.
1
After entering the administrator ID and password, press  or 
repeatedly until >LAN Interface appears.
Using the Operation Panel