Kyocera ECOSYS P2135dn Operation Manual page 180

Password
_
>I/F Block
>>USB Host
? Unblock
>>USB Device
? Unblock
7-74
1
Once you have entered the correct ID in the previous step (ID
(Administrator ID input)), the message display shows Password
(Administrator password input) and a blinking cursor (_).
2
Press  or  to increase or decrease, respectively, the value at the
blinking cursor. Enter the specified password. Use  and  to move
the cursor right and left. Enter a password consisting of between 0 (no
settings) and 16 numbers.
Note If you enter the incorrect administrator ID or password,
the message Wrong ID or Wrong Password appears and
the input screen then reappears. Re-enter the ID or password
correctly.
3
Press [OK]. The Security screen appears.
I/F Block (Interface (external device) block setting)
You can use this to lock and thereby protect the interface. The options
available in Interface Block are as follows:
• USB Host (USB memory slot setting)
• USB Device (USB interface setting)
• Option I/F (Network interface card setting)
• USB Storage (USB memory setting)
1
After entering the administrator ID and password, press  or 
>
repeatedly until >I/F Block > appears.
USB Host (USB memory slot setting)
This locks and protects the USB memory slot (USB host). The default
setting is Unblock.
1
Press  while >I/F Block > is displayed.
2
Press  or  repeatedly until >>USB Host appears.
3
Press [OK]. A blinking question mark (?) appears.
4
Select Block or Unblock using  or .
5
Press [OK].
6
Press [MENU]. The display returns to Ready.
USB Device (USB interface setting)
This locks and protects the USB interface. The default setting is
Unblock.
1
Press  while >I/F Block > is displayed.
2
Press  or  repeatedly until >>USB Device appears.
3
Press [OK]. A blinking question mark (?) appears.
Using the Operation Panel