Using The Remote Control; Inserting Batteries Into The Wireless Remote Control Transmitter Unit; Connecting The Receiver Unit - Sony PCM-D100 Operating Instructions Manual

Using the remote control

You can use the supplied remote control
(receiver and transmitter units) to control
operations such as recording, playback and
track mark settings of the linear PCM recorder.
Inserting batteries into the
wireless remote control
transmitter unit
Before using the remote control, remove the
insulation sheet .
The wireless remote control transmitter unit
will not function properly when the battery is
drained. In this case, follow the steps below to
replace the battery.
1 While pressing tab , insert your
fingernail into the slit to pull out the
battery case.
2
Insert a new battery with the + side
facing up.
30
3
Replace the battery case into the
wireless remote control transmitter
unit until it clicks into place.
Note
The wireless remote control transmitter unit uses a
Sony CR2025 lithium battery. Using a different battery
may cause the risk of fire or explosion.

Connecting the receiver unit

Insert the supplied receiver unit into the
REMOTE jack of the linear PCM recorder.
Rotate the receiver unit so that its remote
sensor faces the front of the transmitter unit.
To REMOTE jack
Receiver unit
Remote sensor