Travis Industries Flush Wood Plus Owner's Manual page 13

Fireplace Insert Installation
•
Install the top panel following the directions below.
•
Install the trim and rheostat following the directions below.
Knock-Out for Power Cord
A knock-out is provided on both sides the trim. Use pliers to remove
the knock-out. This allows the power cord to pass under the trim.
© Travis Industries
HINT: Before installing the top panel, position the insert in its final
location (1-1/4" from the fireplace opening) and attach the flue to
the insert.
Spring Clips
100-01269
(for qualified installers only)
Slide the top panel into place. The joggle clips on
the back of the panel insert over the tabs on the
side panel and the flange on top of the insert.
Trim Installation:
Insert one leg of each "L" bracket into the top and side
trim piece. Align the trim to form a precise corner, then
tighten the two set screws with a small standard
screwdriver. Slide the trim over the panels. Place the
spring clips behind the panels at the locations shown.
This keeps the trim tight against the panels.
Top Trim
Right Side Trim
Attach the rheostat wires (orientation
does not matter).
Micro (1/16")
Slotted
Screwdriver
"L" Bracket
Secure the rheostat
using the included nut
and star washer. The
knob presses into place.
4110712
13