Device Configuration - FLIR DNV14UX2 Instruction Manual

• Frame Rate: Select the frame rate for the stream up to maximum of
30FPS for stream1 or stream2 or 12FPS for stream3.
NOTE: Frame rate may be automatically adjusted to account for bandwidth
limitations.
• I Frame interval: Select the interval for I frames: 1, 2, or 3. The default
value of 2 should be used unless there are special requirements. The I
Frame interval does not apply to stream3.
• Bit Rate: For stream1 or stream2, select CBR (Constant Bit Rate) or VBR
(Variable Bit Rate). Enter the desired bit rate below in kbps. Stream3 only
supports VBR.
• Quality: Select the video quality between 1 (lowest) and 9 (highest).
TIP: A quality of 7 provides a good picture. It is not recommended to set a
high quality value with a small VBR bit rate.
3. Click OK to apply changes.

8.7 Device Configuration

Device Configuration contains the following sub-menus:
• Local Network
• Device Port
• Camera
• Date and Time
• OSD
• Microphone
• BNC Video Output
• Language
• Multicast (Not supported)
• Dome PTZ (Not supported)
Web Configuration
33