FLIR DNV14UX2 Instruction Manual page 18

Camera Installation
4
5
Test cable
terminals
10
Reattaching the Camera Module
3a
3a. Reinsert camera module into
camera base by aligning the arrow
notches on the edge of the camera
module and the camera base
3b
(label on edge of camera module
indicates the location of the arrow
notch), and turning camera
module clockwise to lock into
place.
3b. Use the 3 base locking screws
to secure camera base to camera
module.
Go to step 4 to complete
installation.
4. Remove camera cover by
squeezing the back and front of
the cover (as indicated by the
arrow indicators) at the same
time and lifting it up and away
from the lens.
5. Insert a video test cable into
the video test cable terminals
and connect to a test monitor to
set up camera.
Video Test Cable