How To Modify An Existing Route; Parameters; How To Change Waypoint Position - Furuno FCR-2107 Operator's Manual

10.4

How to Modify an Existing Route

10.4.1

Parameters

Main parameters for the route planning are:
•
Latitude and longitude of the waypoint
•
Channel limits to the waypoint
•
Turning radius of the waypoint
10.4.2

How to change waypoint position

To change position of a waypoint you have following alternatives:
•
Enter latitude and longitude on the WPT page in the Plan Route dialog box.
•
Enter distance and direction for next waypoint.
•
Drag and drop waypoint using the left button.
How to enter latitude and longitude in position field
1. Put the cursor on Route in the sidebar, click the Plan button to open the Plan Route dialog box then click the
WPT tab.
2. Check Enable changes, then choose desired WPT.
3. Put the cursor in the Lat or Lon field as appropriate, spin the scrollwheel to set co-ordinates then push the
scrollwheel to confirm.
How to enter distance and direction for next waypoint
Position of WPT can be defined using distance and direction between two waypoints.
1. Put the cursor on Route in the sidebar, click Plan to open the Plan Route dialog box then click the WPT tab.
2. Check Enable changes, then highlight number of WPT by cursor then push the left button.
3. Click the Next WPT button, and the following dialog box appears.
INSERT/MODIFY NEXT WPT
Current WPT: 1
4. Enter Direction and Distance in respective box in the Next WPT field then click the OK button.
Next WPT
OK
NM
10. How to Plan Routes
10-9