Furuno FCR-2107 Operator's Manual page 159

6. ECDIS Overview
How to select TO waypoint
The system selects a TO waypoint automatically. Check that it is the correct one. Note that waypoint number 1 is
not accepted. Use the Monitor Route menu to select a waypoint.
How to select final waypoint
This selection is used ONLY when the last waypoint should be different than the one defined last in your route. If
needed use the Monitor Route menu to select it.
How to select confirm checked conditions of the route plan
You can check on the Alerts page if checked conditions in the Alerts page are
used with the route in route monitoring.
If the text "Current selection differ" is displayed, use Initial Settings>Chart Alert
parameters to make "Chart alerts" selections.
6-13