Understanding The Leds; Using The Configuration Reset Switch - AMX SIP Communications Gateway CSG-500 Operation/Reference Manual

Sip communications gateway
Hide thumbs Also See for SIP Communications Gateway CSG-500:
Table of Contents

Advertisement

Understanding the LEDs

There are 14 LEDs on the front panel of the CSG. The eight LEDs corresponding to the analog ports on
the rear panel, indicate the type of interface installed. The definition of each LED and its color
representation is explained below.
LED Definitions
LED
Power:
Network:
IP Phones
(4 ports):
Analog (8 ports): • Off

Using the Configuration Reset Switch

The Configuration Reset (CFG RST) switch (rear panel - see FIG. 3) resets the current configuration to
the factory defaults when pressed. The switch must be continuously pressed during the boot process.
This will force the unit to delete all configuration data.
Config Reset
Power
FIG. 3
Rear panel connectors
CSG SIP Communications Gateway Operation/Reference Guide
Color
• Blue (pulsing)
• Off
• Green (flashing)
• Red (flashing)
• Off
• Green (flashing)
• Red (flashing)
• Green (solid)
• Green (flashing)
• Green (slow blinking) Telephone is in use.
• Red (solid)
• Red (flashing)
• Red (slow blinking)
Network port
Console port
IP Phones ports
Description
On when the unit boots up after the bootload process has
completed. The LED pulses at a rate which is proportional to the
processor load.
No line is connected or the interface is inactive.
Link is up at 100Mbps. LED flashes at 1/10 second intervals as
traffic is detected.
Link is up at 10Mbps. LED flashes at 1/10 second intervals as
traffic is detected.
No line is connected or the interface is inactive.
Link is up at 100Mbps. LED flashes at 1/10 second intervals as
traffic is detected.
Link is up at 10Mbps. LED flashes at 1/10 second intervals as
traffic is detected.
No analog port is installed in the corresponding port.
Port is configured for FXS operation and is enabled. An analog
telephone may be connected to this port.
Telephone is ringing.
Port is configured for FXO operation and is enabled. A telephone
line may be connected to this port.
Telephone line is ringing.
Telephone line is in use.
Analog ports
Installation
7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Csg-544Csg-580Sg-500

Table of Contents