Settings For Each Function; Using The Sheet Effectively (Rotate Function) - Rotate Key And Rotate Led - Roland CAMM-1 PNC-950 User Manual

5 SETTINGS FOR EACH FUNCTION

• Using a sheet effectively and cutting along the vertical dimension
(Rotate function) -- ROTATE Key and ROTATE LED
This function sets the origin point at the bottom right and rotates the text or graphics 90° (see pictures below). This
function is used when the intended design will not fit in the width (horizontal dimension) of the sheet, such as long
strings of text. If there is still unused material on the right side, rotation allows you to use this remaining material
effectively.
When the character string "Roland" is rotated by 90°, the X axis, Y axis, and origin change as follows:
0° Rotation - Rotate OFF
Roland Roland
Origin
* The pairs of arrows indicate the positive directions along the X and Y axis.
Procedure
(1) Check that the SETUP LED
has gone out, and press the
ROTATE key.
* If the SETUP LED is illuminated, the ROTATE LED will not light up when the ROTATE key is pressed.
Press the SETUP key to extinguish the SETUP LED, then press the ROTATE key again.
(2) Press the SETUP key.
(3) Send cutting data from the computer.
Canceling the Rotate Function
After holding down the SETUP key for about one second to make the SETUP LED go out, press the
ROTATE key. The ROTATE LED is extinguished, and the origin returns to the point at bottom left.
The ROTATE function is also canceled when the power to the PNC-950 is turned off.
→
ROTATE
→
SETUP
The SETUP LED lights up
90° Rotation - Rotate ON
→
The ROTATE LED lights up
Origin
17