Installation; Before Use; Machine Introduction - Kemppi KMS 400 AS Operating Manual

3.

installatiOn

3.1

BeFOre use

The product is packed in specially designed transport cartons. However, before use always
make sure the products have not been damaged during transportation.
Check also that you have received the components you ordered and the instruction manuals
needed, as described in the Quick start guide pack. Product packaging material is recyclable.
When moving the welding machine, always lift it from the handle, never pull it from the
NOTE!
welding gun or other cables.
Operating environment
This machine is suitable for both indoor and outdoor use. Always make sure that the air flow to
the machine is unrestricted. The recommended operating temperature range is -20...+40°C.
Please ensure you read the safety instructions concerning operating environments supplied in
this manual.
distribution network
All regular electrical devices without special circuits generates harmonic currents into the
distribution network. High rates of harmonic current may cause losses and disturbance to
some equipments.
This equipment complies with IEC 61000-3-12 provided that the short-circuit power S sc
is greater than or equal to 4.7 MVA at the interface point between the user's supply and
the public supply network. It is the responsibility of the installer or user of the equipment
to ensure, by consultation with the distribution network operator if necessary, that the
equipment is connected only to a supply with a short-circuit power S sc greater than or equal
to 4.7 MVA.
EN
3.2

MaChine intrOduCtiOn

H11
S11
H12
X14
X12
F11
H11
H12
S11
X11, X13
6
Fuse for connection for control table
Signal lamp
Warning lamp for thermal protection
Main switch
Welding connection
X11 X13
6.3 A delayed X12 Earth connection
I/O X14 , X15 Connection for control cable
01 Inlet of mains cable
I/O
parallel
01
F11
6,3A
X15
parallel