Typical Multicast Setup - Cisco SF200-24 Administration Manual

Small business 200 series smart switch
Hide thumbs Also See for SF200-24:
Table of Contents

Advertisement

Configuring Multicast Forwarding
Multicast Forwarding
NOTE
Cisco Small Business 200 1. 1 Series Smart Switch Administration Guide
For Multicast forwarding to work across IP subnets, nodes, and routers must be
Multicast-capable. A Multicast-capable node must be able to:
Send and receive Multicast packets.
Register the Multicast addresses being listened to by the node with local
routers, so that local and remote routers can route the Multicast packet to
the nodes.

Typical Multicast Setup

While Multicast routers route Multicast packets between IP subnets, Multicast-
capable Layer 2 switches forward Multicast packets to registered nodes within a
LAN or VLAN.
A typical setup involves a router that forwards the Multicast streams between
private and/or public IP networks, a switch with Internet Group Membership
Protocol (IGMP) snooping capabilities, or Multicast Listener Discovery (MLD)
snooping, and a Multicast client that wants to receive a Multicast stream. In this
setup, the router sends IGMP queries periodically.
MLD for IPv6 is derived from the IGMP v2 for IPv4. Even though the description in
this section is mostly for IGMP, it also describes coverage of MLD where implied.
These queries reach the switch, which in turn floods the queries to the VLAN, and
also learns the port where there is a Multicast router (Mrouter). When a host
receives the IGMP query message, it responds with an IGMP Join message saying
that the host wants to receive a specific Multicast stream and optionally from a
specific source. The switch with the IGMP snooping analyzes the Join messages,
and learns that the Multicast stream the host has requested must be forwarded to
this specific port. It then forwards the IGMP Join to the Mrouter only. Similarly,
when the Mrouter receives an IGMP Join message, it learns the interface from
which it received the Join messages that wants to receive a specific Multicast
stream. The Mrouter forwards the requested Multicast stream to the interface.
15
194

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents