Static And Dynamic Lag Workflow - Cisco SF200-24 Administration Manual

Port Management
Configuring Link Aggregation
NOTE
Cisco Small Business 200 1. 1 Series Smart Switch Administration Guide
The switch supports two modes of load balancing:
• By MAC Addresses—Based on the destination and source MAC addresses
of all packets.
• By IP and MAC Addresses—Based on the destination and source IP
addresses for IP packets, and destination and source MAC addresses for
non-IP packets.
LAG Management
LAG Management
In general, a LAG is treated by the system as a single logical port. In particular, the
LAG has port attributes similar to a regular port, such as state and speed.
The switch supports four LAGs.
Every LAG has the following characteristics:
• All ports in a LAG must be of the same media type.
• To add a port to the LAG, it cannot belong to any VLAN except the default
VLAN.
• Ports in a LAG must not be assigned to another LAG.
• No more than eight ports are assigned to a static LAG and no more than 16
ports can be candidates for a dynamic LAG.
• All the ports in a LAG must have auto-negotiation disabled, although the LAG
can have auto-negotiation enabled.
• When a port is added to a LAG, the configuration of the LAG is applied to the
port. When the port is removed from the LAG, its original configuration is
reapplied.
• Protocols, such as Spanning Tree, consider all the ports in the LAG to be one
port.

Static and Dynamic LAG Workflow

After a LAG has been manually created, LACP cannot be added or removed until
the LAG is edited and a member is removed. Only then will the LACP button
become available for editing.
8
89