Cisco SF200-24 Administration Manual page 186

VLAN Management
Voice VLAN
STEP 1
STEP 2
Cisco Small Business 200 1. 1 Series Smart Switch Administration Guide
To view Auto Voice VLAN parameters:
Click VLAN Management > Voice VLAN > Auto Voice VLAN. The
VLAN
page opens.
The operation status block on this page shows the information about the current
voice VLAN and its source:
• Auto Voice VLAN Status—Displays whether Auto Voice VLAN is enabled.
• Voice VLAN ID—The identifier of the current voice VLAN
• Source Type—Displays the type of source where the voice VLAN is
discovered by the root switch.
• CoS/802.1p—Displays CoS/802. 1 p values that will be used by the LLDP-
MED as a voice network policy.
• DSCP—Displays DSCP values that will be used by the LLDP-MED as a voice
network policy.
• Root Switch MAC Address—The MAC address of the Auto Voice VLAN root
device that discovers or is configured with the voice VLAN from which the
voice VLAN is learned.
• Switch MAC Address—Base MAC address of the switch. If the device's
Switch MAC address is the Root Switch MAC Address, the device is the
Auto Voice VLAN root device.
• Voice VLAN ID Change Time—Last time that voice VLAN was updated.
Click Restart Auto Voice VLAN to reset the voice VLAN to the default voice VLAN
and restart Auto Voice VLAN discovery on all the Auto-Voice-VLAN-enabled
switches in the LAN.
The Voice VLAN Local Table contains local voice VLAN configuration as well as
any voice VLAN configuration advertised by directly connected neighbor devices:
For each port the Best Local Source is indicated, as follows:
• Yes—The switch uses this voice VLAN to synchronize with other Auto Voice
VLAN-enabled switches. This voice VLAN will be the voice VLAN for the
network unless a voice VLAN from a higher priority source is discovered.
Only one local source is the best local source.
• No—This is not the best local source.
12
Auto Voice
178