Cisco SF200-24 Administration Manual page 36

Managing System Files
Downloading or Backing-up a Configuration or Log
Cisco Small Business 200 1. 1 Series Smart Switch Administration Guide
Select either Download or Backup as the Save Action.
Download Save Action—Specifies that the file on another device will replace a
file type on the switch. Enter the following fields:
a. Server Definition—Select whether to specify the TFTP server by IP address
or by domain name.
b. IP Version—Select whether an IPv4 or an IPv6 address is used.
If the server is selected by name in the Server Definition, there is no
NOTE
need to select the IP Version related options.
c. IPv6 Address Type—Select the IPv6 address type (if used). The options are:
- Link Local—The IPv6 address uniquely identifies hosts on a single
network link. A link local address has a prefix of FE80, is not routable,
and can be used for communication only on the local network. Only one
link local address is supported. If a link local address exists on the
interface, this entry replaces the address in the configuration.
- Global—The IPv6 address is a global Unicast IPV6 type that is visible
and reachable from other networks.
d. Link-Local Interface—Select the link local interface from the list.
e. TFTP Server—Enter the IP address of the TFTP server.
f. Source File Name—Enter the source file name. File names cannot contain
slashes (\ or /), the leading letter of the file name should not be a period (.), and
the file name should be between 1 and 160 characters. (Valid characters: A-Z,
a-z, 0-9, ".", "-", "_").
g. Destination File Type—Enter the destination configuration file type. Only valid
file types are displayed. (The file types are described in the
Types section.)
4
Files and File
28