Table of Contents
Advertisement
Recording
Recording to a Tape Player
Input signals from an audio source playing in the DMC-1 can be recorded using the left and
right audio outputs. The tape player will receive a straight copy of the analog source signal
going in, unaffected by the volume, tone, or any surround modes. If you are playing a digital
source, the tape player will receive a down mixed stereo analog signal for recording.
• Select the source (such as CD) and play it through your system.
• Set your tape player to record and adjust the input levels for the best performance. Once the
levels are correct, you can reset your source to the beginning and make your recording.
• Do not select another Main Zone input while you are recording.
De sig
ne d in
Bu ilt wit
US A
h pri de
in Ch ina
Desig
ned in
Built with
USA
pride
in China
1
Connect "PLAY" from
1
DMC-1 to Tape INPUTS
Connect "RECORD" from
2
DMC-1 to Tape OUTPUTS
Recording to a VCR
Any video source playing in the DMC-1 can be recorded using the left and right audio and the
video outputs. The VCR will receive a straight copy of the source signal going in, unaffected
by the volume, tone or any surround modes.
• Select the video source and play it through your system.
• Set your VCR to record.
• Do not select another Main Zone source while you are recording.
• The VID2/MON2 output can also be used for recording, but first make sure that it is set to
VID2 in the VIDEO menu of the OSD (see page 61). This output will then mute to prevent
feedback whenever the VID2 input source is selected.
• Do not use the OSD while recording as the incoming video is shut off while the OSD is
displayed
2
De sig
ne d in
Bu ilt wi
US A
th pr ide
in Ch ina
Desig
Built with
ned in
USA
pride
in China
VI DE O
IN
Connect "PLAY" from
3
DMC-1 to Tape INPUTS
3
4
VI DE O
OU T
Connect "RECORD" from
4
DMC-1 to Tape OUTPUTS
Page 69
Advertisement
Table of Contents
