Recal (Recall); Clone - Emotiva DMC-1 User Manual

RECAL (Recall)

This mode lets you quickly see the three digit codes you have assigned to each device. This
is useful if you want to check the tables and find other codes which may work better.
1) In the SETUP mode, select RECAL. The device labels and their codes will flash alternately,
before returning to the SETUP menu. Make a note of the codes.
2) Press MAIN to return to the main device menu.

CLONE

This feature allows you to easily copy all of the commands and labels from one Emotiva
remote (of the same type) to another.
1) Set both remotes on a flat surface, with their IR windows pointing towards each other,
about 1 or 2 inches apart.
2) In the SETUP menu for both remotes, press CLONE and the display will change to show
SEND, RCV (receive) and EXIT.
3) Press SEND on the remote you want to copy from. Press DEVIC to only clone a single
device, then press the device button. Press ALL to clone all programming.
4) Press RCV on the remote you want to copy to.
5) When you are ready, press START on both remotes. It may take up to 1 minute to complete
the clone sequence so do not move the remotes during this time. The remote will flash "GOOD"
if it has successfully learned all the commands. If it flashes "FAIL," then repeat this procedure.
6) Press MAIN to return to the main menu.
Page 49