Z Ii (Zone 2); Input Select Buttons; Mode Up/Down (Mode Buttons); Am/Fm Tuner Controls - Emotiva DMC-1 User Manual

5

Z II (Zone 2)

Any changes you make after pressing
this, will affect Zone 2 and not the Main
Zone. For example, press Z II, then
POWER to turn on Zone 2, then adjust
the Volume and select an input. Press Z
II again to revert back to Main Zone op-
eration. It will also revert back after a short
period of no activity.
Note: If Zone 2 has not been enabled this
button has no effect. The unit is shipped
with Zone 2 disabled.

Input Select Buttons

6
Use these controls to select the source
that you want to listen to and/or view. Us-
ing the On Screen Display (OSD) IN-
PUTS menu, each input can be adjusted
in level so that all the inputs have similar
volumes. Each input can also be set to
enter a desired surround mode whenever
that input is selected.
Note: After you have selected an input,
you should check that the DMC-1 is set
to the desired surround mode (or the ste-
reo mode).

MODE UP/DOWN (Mode Buttons)

7
These buttons allow you to step up or
down through the various sound play-
back modes.
8

AM/FM Tuner Controls

The AM/FM button toggles between the
AM or FM band. Press and hold it to scan
of the station presets. Press it again or
press a preset button to stop the scan.
DIRECT Tuner Controls
Use this to enter a station's frequency
directly using the 0 - 9 keys, such as 9,
3, 9 for 93.9 MHz.
UP/DOWN Tuner Controls
Switch to stations above or below the fre-
quency of the current station. If repeat-
edly pressed, the tuner will move up or
down one frequency step each time. If
held down for a second or more, the
tuner will automatically keep tuning sta-
tions. Press UP or DOWN once again
to stop when it reaches a station you like.
Preset Tuner Memory Buttons
1-9, 0, +10 -These buttons are used to
directly select your favorite stations, pre-
viously stored as presets.
9

Tone Controls

To change the tone, first press BASS or
TREBLE and then press UP or DOWN
to suit your taste. The display will show
the change in dB level for reference. The
range for both BASS and TREBLE is +/
- 10 dB in steps of 1 dB. The unit returns
to its normal display after a few moments
of inactivity, and any level changes are
retained.
The BASS and TREBLE levels can also
be adjusted using the OSD TONE Menu
and the remote control.
Note: The Tone controls do not affect the
LFE channel, or the 8-Channel analog
input.

Signal Processing Indicator Lights

10
DOLBY DIGITAL
This light is on when a Dolby Digital sig-
nal is being decoded.
DTS
This light is on when a DTS signal is
being decoded.
DOLBY PRO LOGIC IIx
This light is on when the Dolby Pro Logic
II or Pro Logic IIx mode is engaged.
DIGI
This light is on when a digital audio sig-
nal is being decoded.
Page 15