Emotiva DMC-1 User Manual page 40

this, please refer to the connection diagrams in the subsequent sections of this guide.
Safety Precaution - Make sure that all of your equipment remains unplugged from the AC
mains until you have made all the connections.
Step 3 - Connect the speakers to your amplifier(s) so you will be able to hear sound.
Step 4 - If you are using a new DVD player or had previously configured it with 2-channel
(RCA type) analog audio connections, you may need to configure the output to digital audio.
In your DVD player's AUDIO SETUP MENU, you must set the digital output to BITSTREAM.
If this is not set correctly, the DMC-1 cannot decode the digital information for discrete sur-
round sound playback.
Step 5 - The DMC-1 has a bass management system which allows the damaging bass from
each full range channel to be redirected to a subwoofer. Larger speakers can typically play
the full frequency range, however you may choose to have smaller speakers (such as satel-
lite types) can have the bass redirected to the subwoofer(s). Make a note of which speakers
you would like to play the full frequency range (Large) and those which will have the bass
redirected (Small). Also make a note of the approximate distance of each speaker from your
listening position.
Step 6 - Turn on the DMC-1
Step 7 - Turn on your amplifiers, TV and other source equipment.
Step 8 - Press the remote MAIN button - a few times to make sure you are on the Main Menu
in the remote's display.
Step 9 - Set the remote to operate the DMC-1 by pressing the EMO button.
Step 10 - Turn down the DMC-1 volume and use the remote or front panel input selector to
select a video source.
Step 11 - Play the source, and bring up the volume to a low level. Make sure the video can be
seen in the TV monitor.
Step 12 - Stop or pause the source.
. The DMC-1 now needs to be setup correctly to suit your speakers and system. The SET-
TINGS (OSD) menu is used to enter and make three main ad-
justments:
· Speaker Size
· Speaker Calibration
· Speaker Position
This setup needs to be done when you use your system for the
first time, or if you change anything such as the amplifiers or speak-
ers, or the speaker position. The calibration is also a good way to
check that your system is working correctly. These adjustments are made using the
OSD as follows:
Step 13 - Press MENU on the remote to bring up the MAIN Menu of the OSD on
your TV.
Step 14 -Use the joystick pad left, right, up and down buttons to navigate through
the menus in the next steps.
Joystick
Step
13
Page 40