Table of Contents
Advertisement
7) The commands are sent in sequence, for example for channel 13, first the 1 and then the 3
are sent. Wait a few seconds before switching between favorites, or your TV may receive for
example, the 1 of one button and the 2 of the next.
PUNCH
This mode allows you to set up the volume, channel up/down and transport buttons so they
will work for your main devices, no matter which device the remote is set for. For example, the
volume buttons can operate the TV, even if the remote is set to VCR. The channel buttons can
operate the VCR, even if the remote is set to TV.
1) In SETUP, select PUNCH and the display changes to show VOL, CH, and PLAY. The PLAY
selection will make the eight transport buttons around the joystick "punch" through.
2) Select one of these buttons, for example VOL.
3) Press a device button for the device you want the Volume commands to appear in (punch
TO).
4) Press a device button for the device you want to learn from (punch FROM). These settings
are saved.
5) Repeat steps 2 to 4 until you have punched to all devices you want.
6) Use MAIN to return to SETUP.
NOTE: To erase Punch commands from a device (return buttons to their previous program-
ming): Repeat steps 1 and 2, then press the device button twice. Repeat for other devices,
then press MAIN to return to SETUP.
ERASE
Use this mode to erase commands stored in the remote. This does not affect the labels, just
the stored IR commands. The pre-programmed commands for the DMC-1 can be lost. Please
follow this section CAREFULLY!
1) In the SETUP mode, select ERASE and the display will show LEARN, FAV, MACRO and
EXIT.
2) If you select LEARN, press ALL to erase all learned buttons, or KEY to erase one device at
a time. If you use KEY, press MAIN and EXIT when you have erased all the devices you want.
NEVER select ALL! This will erase the EMO operating codes and the remote will have
to be sent to the factory for re-programming.
3) If you select FAV, press ALL to erase all favorites, or KEY to erase single favorites. Note
that the labels are not erased.
4) If you select MACRO, press ALL to erase all macros, or KEY to erase macros, one device
at a time.
5) Press EXIT to return to the SETUP menu, and press MAIN to return to the main device
menu.
LIGHT
This mode allows you to either disable the light, or change the number of seconds it stays on.
(The light is inactive while in the SETUP mode).
Page 47
Advertisement
Table of Contents
