Table of Contents
Advertisement
SETTINGS Menus (Continued)
SOFTWARE Menu
This menu is used to show the current revision levels of system
software within your DMC-1. It also allows the DMC-1 Flash
memory software to be upgraded by use of the RS-232 port.
Please note that to accomplish the software upgrade, you
will need to connect the DMC-1 to a computer with a serial
cable (DB-9 type). The latest version of the DMC-1 soft-
ware is available on the Emotiva website. You will need to
download this to your computer before connecting and
upgrading the DMC-1.
For detailed instructions on this procedure and to check
for the latest software version, please visit the Emotiva
website at www.emotivaaudio.com.
CONTROL Menu
In most cases, there is no need to change these settings (all
enabled by default). You should make any changes with caution.
This menu allows you to enable or disable the RS-232 port and
the rear panel IR remote control connections. The front panel
IR receiver can also be disabled if required, but make sure
the rear panel IR receiver is working correctly and is still ac-
tive before doing this.
The front panel IR can be re-enabled by holding down
the remote's MENU button for several seconds, while
pointing it at the front IR window.
Page 62
Advertisement
Table of Contents
