Emotiva DMC-1 User Manual page 25

Here are two connection options:
See Option 1
OPTION 1
Note Below
Use either output to activate
the MAIN ZONE amplifier(s)
These terminals can
be secured with a
small "jewelers"
screwdriver
12 VDC output whenever
OPTION 2
MAIN ZONE is selected
Option 1
This shows independent 12 VDC outputs that will turn on any compatible external amplifier
with a 12 VDC trigger input. Use the middle relay contacts to enable another independent
device that will turn on (as the contacts close) whenever a "trigger enabled" input in the MAIN
ZONE has been selected. DO NOT use the center relay contacts for 120 VAC or 240 VAC
switching! They are only for low voltage AC/DC loads of 2 A maximum. Typically this will mean
low voltage control of structured lighting systems, automated window coverings, or other low
voltage devices. Never switch anything that plugs directly into the wall with these on-
board contacts. This action will damage the unit and VOID THE WARRANTY.
Option 2
This simply shows looping the 12 VDC into the relay contact to turn on a device using the
available 12 VDC trigger already supplied.
Page 25