Table of Contents
Advertisement
DMC-1 Front Panel Features
8
1
Power Button
This turns the DMC-1 on or off. It is a
non-latching momentary button. If you
press Z II first, it can turn on Zone 2
(even if the Main Zone is off).
IMPORTANT – Please note the DMC-1
requires initialization after the power
cord is plugged into the AC receptacle.
Push and hold the power button for
approx. 5 seconds. The unit will power
up after this small delay. The second
push of the power button will turn the
unit off and after this the unit will turn
on and off in a normal fashion.
IR Receiver Window
2
This window should be clean and free
from obstruction for the remote control
to work correctly.
3
Processor Display
This soothing blue display shows which
input is selected, the tuner frequency,
volume level, and other useful informa-
tion.
6
7
9
10
1
2
3
4
Rotate this manual control clock-wise to
increase the volume. The dB level will
appear in the front panel display. When
turning on a new source, make sure the
level is low, such as -80 dB and increase
it slowly. The dB display becomes less
negative as the volume increases.The
DMC-1 volume control is velocity sensi-
tive. If turned slowly, the volume will
change in small increments. If rotated
quickly, level change will be made in
larger increments.
Note: When the DMC-1 is turned on, it
has a deliberately slow and smooth vol-
ume ramp from silence, up to the level
that was set when the unit was last
turned off. It can also be programmed
to come up to a preset volume you have
selected, rather than the previous
volume.The knob does not turn when
volume is operated from the DMC-1 re-
mote.
5
4
Page 14
Advertisement
Table of Contents
