Table of Contents
Advertisement
DMC-1 Rear Panel Layout (Continued)
1 1
1 2
1 3
1 4
FM Antenna
1 1
The supplied FM antenna fits this "F-type"
screw-on connector. Other antennas can
be fitted for improved reception.
1 2
AM Antenna
These connections are for the included
AM loop antenna.
1 3
Ground Screw
This is commonly used for the ground
connection wire of a turn-table, to pre-
vent any hum in your speakers. It is tied
to the chassis ground, and may be used
as needed.
Note: It is not necessary or desirable to
connect this to an electrical ground.
1 4
Audio Inputs
These audio inputs connect to the out-
puts of your turntable, DAT or TAPE
player. Any standard audio component
with a line-level output can be connected
to DAT or TAPE. Only a turntable with a
moving-magnet, or high-output moving
coil cartridge can be connected to the
PHONO input.
1 5
1 9
1 6
1 5
Audio Outputs
These audio outputs connect to the ana-
log record inputs of your tape decks, such
as DAT, cassette or reel to reel. These
outputs allow you to record the selected
audio program. Note that these also al-
low analog recording from digital audio
sources.
1 6
Stereo Outputs
FIXED MAIN is a line level output, and
the volume is not adjustable. This can
be used as a record output, or to feed
another audio system. ZONE 2 connects
to the inputs of a stereo amplifier to run
Zone 2. The volume and source are ad-
justable, either from the front panel, or
from a remote IR sensor.
1 7
Side-Axis Outputs
These outputs provide two optional front
side channels to complement the left,
center, right, surround and surround back
channels. They can be turned on or off
using the Speaker Size OSD menu (see
page 56).
21
20
1 7
1 8
Page 19
Advertisement
Table of Contents
