Table of Contents
Advertisement
DMC-1 Rear Panel Layout
1
Audio/Video Inputs
1
These Audio, Component Video, Com-
posite-Video and S-Video inputs connect
to the outputs of your audio video com-
ponents. When these inputs are se-
lected, the audio will be heard in your
system and the video will be seen on
the TV screen. VID2 can be used for a
second VCR.
3
Component Video In
These inputs connect to the component-
video outputs of your DVD, SAT or other
video source (VID1) if they have this ad-
vanced capability. When these inputs are
selected, the DMC-1 will automatically
route any video signals going into these
jacks to the component video outputs.
Note that component video provides the
best picture compared to composite or
S-Video. The DMC-1 can also route
HDTV signals.
4
Component Video Out
If your TV Monitor has component video inputs, connect them to these outputs. If you
select DVD, SAT or VID1, then any video signals going to the component inputs, will
pass through to your TV monitor. The DMC-1 can also up convert any Composite Video
or S-Video signals from the other inputs to Component Video.
2
3
1 0
2
4
5
6
7
9
Audio/Video Outputs
MAIN: connects to the inputs of a TV
monitor, where the video of any selected
input and the On Screen Display (OSD)
can be viewed. The audio connections-
allow you to listen to any selected audio
source through your TV's speakers.
VCR: connects to the inputs of a VCR to
allow recording.
VID2/MON2: connects to the input of a
second VCR for recording, or to a sec-
ond TV. When configured in the OSD for
"VID2," this output is muted whenever the
VID2 input is selected. This prevents
feedback; also there is no OSD then on
this output. When configured for "MON2,"
the output is always active, the same as
the Main output.
Note: Analog audio signals are present
at these L and R outputs even if a digital
input has been selected. The output is a
2 channel down mix if the digital source
has more than 2 channels.
8
Page 17
Advertisement
Table of Contents
