Section 16: Plumbing The Engine - Hangar 9 Solo Instruction Manual

Section 16: Plumbing the Engine

Parts Needed
• Fuselage with engine mounted
• Muffler
1. Install the muffler per the instructions included with the
engine. Now is a good time to install your glow plug if you have
not done so.
48
Tools and Adhesives Needed
• Hobby knife
• Phillips screwdriver (medium)
2. Connect the vent tube from the fuel tank to the pressure fitting
on the muffler. Remove the masking tape at this time.
3. The remaining tube should be attached to the carburetor fuel
inlet nipple.