Installing The Receiver - Hangar 9 Solo Instruction Manual

Section 14: Installing the Radio and Centering
the Servos
5. Remove the servos and drill the 12 mounting holes as
marked using a 1/16'' drill bit. Re-install the servos, again
noting the position of the output horns.
Screw the servos in place using the 12 servo screws included
with the servos.

Installing the Receiver

and Battery Pack
6. Use 1/4'' radio packing foam (available from your local
hobby dealer) when installing the receiver and battery pack. With
a sharp hobby knife, cut a solid layer of foam to the size of the
compartment in front of the servo tray. Cut out another layer of
foam that's identical in size, however, cut an opening in the
center of this foam so it will accept the receiver battery pack.
Place another solid layer of foam on top of this layer. Cut
another layer of foam to accept the receiver. The final layer of
foam should be solid.
7. Place the layers of foam with the battery and receiver in the
front compartment of the fuselage as shown. Route the antenna
back through the fuselage using an antenna tube (not included),
or route it outside the fuselage back to the vertical stabilizer.
CONTINUED
39