Memory (Bank) Scan - Icom COMMUNICATIONS RECEIVER IC-R3 Instruction Manual

6
SCAN OPERATION

Memory (bank) scan

q Select memory mode with [V/M].
w For memory bank scan, rotate [DIAL] while pushing
[FUNC] to select the desired memory bank.
e Make sure the squelch is set to the threshold point.
• Select automatic squelch (AUTO) or a level (1–9) where the
noise is just muted. (p. 11)
r Push and hold [↔], then rotate [DIAL] to turn the memory
bank scan ON or OFF.
• "ALL" indicates all memory banks are scanned (memory bank
scan OFF); "BANK" indicates the selected memory bank is
scanned (memory bank scan ON).
FM
146.100.000
TS
BANK
S1 3
VOL
Bank scan ON
20
PSKIP FM PSKIP
M:A00 M:A00
146.100.000
15.0 TS 15.0
ALL
5 7 9 S1 3 5 7
VOL
Bank scan OFF
t Release [↔] to start the scan.
• Decimal point(s) flashes while scanning.
• To change the scanning direction, rotate [DIAL].
• If the pocket beep function is activated, the receiver automatically
selects the tone squelch function when a scan starts.
y To stop the scan, push [↔] again.
9