Icom COMMUNICATIONS RECEIVER IC-R3 Instruction Manual page 27

e Push [↔] or rotate the tuning dial while pushing [FUNC] to
select the desired scan pause time.
• "2SEC"–"20SEC" : scan pauses for 2–20 sec. on a received sig-
nal.
• "HOLD" : scan pauses on a received signal until it dis-
appears.
r Push [(MODE) SET] to exit set mode.
Pause Scan : 10SEC Pause Scan : 10SEC
Priority : OFF Priority
Beep Audio : VOLUME Beep Audio : VOLUME
Light : AUTO Light
A.Power OFF : OFF A.Power OFF :
Scan pause time set 10 sec. pause time
mode
◊ Setting the scan resume time
The scan restarts after a signal disappears according to the
resume time. It can be set from 0–5 sec. or unlimited.
q Push [FUNC] + [(MODE) SET] momentarily to enter set
mode.
• Select a non-band scope screen in advance for color LCD.
Pause Scan : HOLD
: OFF Priority : OFF
Beep Audio : VOLUME
: AUTO Light : AUTO
OFF A.Power OFF : OFF
Pause scan
w Rotate [DIAL] until "Scan Resume" or "RESUmE" appears.
• "RESUmE" disappears after 1 sec. and the previously selected
scan resume time and "RE" appears when color LCD is OFF.
e Push [↔] or rotate the tuning dial while pushing [FUNC] to
select the desired scan resume time.
• "1SEC"–"5SEC" : scan restarts 1–5 sec. after the signal disap-
pears.
• "0SEC" : scan restarts immediately after the signal dis-
appears.
• "HOLD" : scan restarts by rotating [DIAL] only.
r Push [(MODE) SET] to exit set mode.
Tone Squelch: OFF Tone Squelch:
Tone Freq. : 88.5 Tone Freq. :
Duplex : OFF Duplex
Offset Freq.: 0.600 Offset Freq.:
Scan Resume : 2SEC Scan Resume : 2SEC
Scan resume time 2 sec. resume time
set mode
6
SCAN OPERATION
OFF Tone Squelch: OFF
88.5 Tone Freq. : 88.5
: OFF Duplex : OFF
0.600 Offset Freq.: 0.600
Scan Resume : HOLD
Scan resumes by
rotating [DIAL] only.
23