Panasonic HC-X920 Operating Instructions Manual page 138

∫ When connecting by [Set Manually]
1
Touch [Set Manually].
2
Touch [INPUT], then Enter the SSID of the wireless access point to be
connected.
≥ For details on how to enter characters, refer to page 73.
≥ When the entry is complete, touch [Enter].
3
Touch [NEXT], and then touch the desired Network Authentication method.
Network authentication type
[Open]
[WEP]
[WPA-PSK]/[WPA2-PSK]
≥ When [WEP] is selected, proceed according to step 5.
4
Touch the desired Encryption method.
≥ If you select [NONE], a message is displayed after completing the connection.
5
(When selecting [WEP]/[TKIP]/[AES])
Touch [INPUT], then enter the Password.
≥ For details on how to enter characters, refer to page 73.
≥ When the entry is complete, touch [Enter].
6
Touch [NEXT].
≥ A message is displayed when the connection is complete.
Confirming that the Wi-Fi connection is complete
j The status indicator of this unit is lit green
is displayed on the screen
j
When the preparations for the Wi-Fi function
complete, you can use the following functions:
j [Remote Ctrl] (l
j [DLNA Play] (l
j [Live Cast] (l
j [Hom.Monitor]
≥ Check the wireless access points instruction manual and settings when a saving wireless access
point.
≥ The Encryption methods are [AES], [TKIP] and [WEP] in descending order of strength. We
recommend you connect with the strongest possible Encryption method.
≥ If no connection can be established, the wireless access point's radio waves may be too weak.
Refer to "Messages"
≥ Transmission speed may decrease, or may not be usable depending on the environment it is
used in.
143)
147)
148)
(l 152)
(l 183) and "Troubleshooting"
Encryption types that can be set
[NONE]/[WEP]
There is no setup of an encryption types.
[TKIP]/[AES]
(l 129) and the Wi-Fi connection are
(l 185) for details.
- 138 -