Marquis Spas Destiny Owner's Manual page 61

SANITIZE
ConstantClean™ System (option)
The ConstantClean™ system utilizes a combination of sanitizers to in-
crease water quality and significantly decrease maintenance. The combina-
tion of a Spa Frog® Mineral Cartridge* and the factory installed ozonator
greatly reduce the amount of sanitizer required. Instead of the normal 3 - 5
ppm of bromine, you may only need to maintain 1 - 2 ppm of bromine.
NOTE: The use of Spa Frog® floating cartridges is recommended. Do not
use other floating chemical dispensers or Biguanide. Damage to the spa
shell and other internal components can occur.
* The built-in sanitation system is not available in some international mar-
kets. However, the ozone system is available on all spa models in all
countries. Please see your dealer for recommended alternate treatment
method if the built-in sanitation system is not available.
BUILT-IN SANITATION SYSTEM*
After shocking the spa water with Chlorine Sanitizer granules or non-
chlorine Spa Shock, bring the spa water to operating temperature. Then
install the Spa Frog® cartridges.
ADJUST THE MINERAL CARTRIDGE
Remove the protective cellophane wrap from the Spa Frog® mineral
cartridge. While holding the bottom of the cartridge, turn the top until the
number six appears in the setting window.
NOTE: The mineral cartridge should be replaced every three to four
months. You will still feel the "spent" minerals inside, but they are no longer
effective and the cartridge needs to be replaced. It is recommended to
drain and refill the spa at the same time you replace the mineral cartridge.
ADJUST THE BROMINE CARTRIDGE
Remove the protective cellophane wrap from the Spa Frog
cartridge. Finding the right setting for the bromine cartridge will require
monitoring your usage for the first few weeks. Begin with an initial setting
based on the chart below and monitor bromine levels daily for the first
week or so, adjusting the cartridge by one setting per day until a 3 - 5 ppm
level has been achieved. To adjust cartridge, remove from system and turn
to the next highest setting if the bromine level is low or the next lower
setting if the bromine level is high. The bromine cartridge needs to be
replaced when empty between two and four weeks. Always maintain 3 - 5
ppm of bromine.
Suggested Initial Bromine Cartridge Settings
Daily filter time
One hour
Two hours
Four hours
M A R Q U I S C A R E & E N J O Y M E N T G U I D E
Spa Gallons
250-300 300-400
2 3
2 2
1 2
® bromine
400-500
4
3
2
61