Marquis Spas Destiny Owner's Manual page 39

S P A C O N T R O L O P E R A T I O N
JETS
Use the JETS pad on the bather panel or remote control.
First press of the JETS pad activates pump on low-speed
(and starts soak timer). Second press of the JETS pad
activates pump on high-speed. Third press of the JETS
pad turns jets off for all-quiet mode. Fourth press of the
JETS pad turns pump back to low-speed. If the pump is
already on low (heating, filter cycle) then the first press
starts the soak timer. After running on low- or high-speed
for 15 minutes, the pump automatically turns off (unless in
heating or filtering cycle).
SOAK TIMER
The soak timer starts the first time you press a JETS
pad. The LCD window displays the elapsed time (1-30)
for 55 seconds then switches to the current water
temperature for five seconds then back to the timer. It
continues to alternate for the entire 30 minutes. The
timer runs for 30 minutes regardless of other functions
in use (jets, temperature, or light). You can manually
cancel the timer by pressing the TEMP+- pad and then
the LIGHT pad.
REMOTE CONTROL (OPTION)
NOTE: During times of inactivity, wireless remotes
should always be stored in the cup holder on the lip of
the spa or removed from the spa. By storing the
wireless remote out of water, it will be less susceptible
to water intrusion, a situation that can occur after
extended water exposure. More often, water intrusion
occurs when spa owners attempt to replace the
batteries in their remote and then do not properly reseal
the remote. Battery replacement should only be
performed by spa care professionals. Batteries and
water intrusion into remote controls is not covered
under the warranty. Remote controls do not qualify for
labor coverage. These parts can be purchased or
exchanged under warranty at your authorized Marquis
Spas ® dealer.
CONSTANTCLEAN™ WATER MANAGEMENT
WITH BUILT-IN SANITATION SYSTEM
(See Built-in Sanitation System page 53)
Factory Default Settings:
• Filter Cycle Duration: F2 (2 hours)
• Filter Cycles: 2C (twice per day)
• Smart Logic: 1H (1 hour)
These settings represent the most commonly used
settings, but your use may be different, depending
upon many variables – frequency, number of bathers,
duration, water capacity, etc. These variables affect the
quality of water and the way it should be managed to
39