Marquis Spas Destiny Owner's Manual page 41

S P A C O N T R O L O P E R A T I O N
Selectable SmartClean™ Settings
• 1H: 1 hour
• 2H: 2 hours
• 3H: 3 hours
• 4H: 4 hours
• OH: Off
To adjust the SmartClean™ settings:
Use the TEMP+- pad to scroll through options. When
desired selection has been reached. Press SETTING pad
to enter selection and exit settings mode.
TEMPERATURE DISPLAY AND ADJUSTMENT
Factory Default Settings:
• Temperature: 102°F (39°C)
The LCD window displays the actual water temperature.
Pressing the TEMP+- pad makes the numbers flash, then
pressing the pad again (repeatedly) increases the set
temperature one degree at a time, up to 104°F (40°C).
After a short pause, the actual temperature displays. Press
TEMP+- pad repeatedly to decrease the set temperature
to 80°F (27°C).
HEAT LIGHT
The HEAT light illuminates when the heater is on. The
pump circulates on low-speed whenever the thermostat
calls for heat.
HEAT MODE
Your spa comes preset in the standard heat mode. The
heat mode can be adjusted to one of three different
settings:
Standard Mode (St)
The spa water heats to the temperature as set at the
bather's panel. In this mode the filtration pump turns on
for two minutes every half-hour to "poll" or check the
water. If heat is needed the unit heats to the set tempera-
ture. The LCD window steadily displays the actual tem-
perature in this mode.
Economy Mode (Ec)
In this mode the spa only heats to the set temperature
during a filter cycle. The LCD window displays "Ec"
alternately flashing with the actual temperature when the
spa is up to temperature and "Ec" steadily when the
spa's water temperature is below the set
temperature.
41