Marquis Spas Destiny Owner's Manual page 44

S P A C O N T R O L O P E R A T I O N
SETTINGS
Clock
Press the CLOCK pad followed by the SETTING pad.
"Program" will be shown in the upper left corner of the
panel display and the hour will begin flashing. To adjust,
press the TEMP+ or TEMP- pad. Once the correct hour
has been set, press SETTING pad to set the minutes.
"Minutes" will flash. Follow above procedure to set the
correct minutes.
Filter Cycle 1:
Press the CLOCK pad followed by the SETTING pad
three times to enter Filter 1 programming. "Program filter 1
start time" will be shown in the upper left corner of the
panel display and the hour will begin flashing. To adjust,
press the TEMP+ or TEMP- pads. Once the correct hour
has been set, press SETTINGS pad to set the minutes.
Follow above procedure to set the correct minutes. Press
the SETTING pad again and "Program filter 1 end time" will
be shown in the upper left corner of the panel display and
the hour will begin flashing. Follow above procedures to
set the correct hour and minutes. NOTE: When in a filter
cycle the Filter Cycle LED will illuminate.
Filter Cycle 2:
Press SETTING pad to enter filter 2 programming mode.
"Program filter 2 start time" will be shown in the upper left
hand corner of the panel display and the hour will begin
flashing. Follow above procedure to set the correct hour
and minutes. Press the SETTING pad again and "Program
filter 2 end time" will be shown in the upper left corner of
the panel display. Follow above procedure to set correct
hour and minutes.
Spa Light:
Press SETTING pad to enter spa light programming
mode. The light icon will begin flashing at the bottom
of the panel display. "Start time" will be shown in the
upper left hand corner of the panel display and the
hour will begin flashing. Follow above procedure to set
the correct hour and minutes. Press the SETTING pad
again and "end time" will be shown in the upper left
corner of the panel display and the hour will begin
flashing. Follow above procedure to set the correct
hour and minutes. Press the CLOCK pad to exit the
programming mode.
NOTE: Any time during the setting of features you may exit
the programming mode by pressing the CLOCK pad. If you
don not want to run any of the filter modes or spa light
cycles, set the start and end times for the same time.
44