Marquis Spas Destiny Owner's Manual page 45

S P A C O N T R O L O P E R A T I O N
HEAT MODE
Your spa comes preset in the standard heat mode.
Allow about one hour per one degree F for heating your
spa water when increasing the temperature to the
desired level.
The heat mode can be adjusted to one of three different
settings:
Standard Mode
The spa water heats as necessary to maintain the set
temperature. "Standard" will display until the mode is
changed. NOTE: The last measured temperature
displayed is current only when Pump 1 has been running
for at least two minutes.
Economy Mode
In this mode the spa only heats to the set temperature
during a filter cycle. The "Economy" icon will display until
the mode is changed. Press the JETS 1 pad to put the
spa in "Standard-in-Economy" mode which operates the
same as Standard mode (both Economy and Standard
will display). The spa reverts to Economy mode automati-
cally after one hour.
Sleep Mode
The spa water heats to within 20°F (7°C) of the set
temperature only during filter cycles. "Sleep" will display
until the mode is changed.
To Adjust Heat Mode
First press the SETTINGS pad. The current heat mode
will start flashing. Use the TEMP- pad to scroll through
the modes. When desired mode is displayed touch the
SETTINGS pad again to lock the mode.
Panel Lock
Press TEMP+ or TEMP- pad followed by QUIET SOAK pad
to lock. Then press TEMP+ or TEMP- pad followed by
QUIET SOAK pad to unlock.
• Lock feature locks all user settings: time, filter cycles,
heat modes, SmartClean™ and temperature settings.
• Lock feature does not lock Jets 1, Jets 2, Timer,
Spa Light, Waterfall Light, Quiet Soak, or Clock.
• Secured LED will illuminate when system is locked.
45