Soundsations - Marquis Spas Destiny Owner's Manual

+
R
-
-
L
+
Wire connections.
WARNING! Never use broken or frayed wire, as
damage or electrical shock may result.
CAUTION! Exposing too much wire or having wires
with frayed ends could cause wires to touch each
RED
other, which could damage the equipment.
BLACK
3. Wire connections
WHITE
A. Red = Right (+)
GREEN B. Black = Right (-)
C. White = Left (-)
D. Green = Left (+)
NOTE: Do not connect speaker cord to any speaker
terminals already in use.
4. Check all connections to the stereo receiver.
Make sure all wires are connected in phase
(+ to + and – to –). Correct any wiring problems
before reconnecting the stereo receiver to the
power source.
You should perform a routine inspection (every
three months) of the Soundsations™ Audio System
to ensure that the system is operating properly.
If the cord or cord-connection is damaged; if the
door to the equipment compartment shows signs
of deterioration; if excessive water is entering the
equipment compartment; or if there are other signs
of damage to related components, turn off the spa
and have the damaged component repaired by a
qualified service person.
Recommended components
Use stereo receivers rated from 60 to 120 peak watts
per channel and rated from 8 to 16 ohms.
The Soundsations audio system has automatic
protection circuits to protect against overload. This
circuit activates at high volume levels to reduce
output, causing a decrease in volume. This is normal
operation and indicates that the power input may be
exceeding safe levels. If this protection circuit has been
activated, turn down the volume to allow the system to
reset itself and resume normal operation. Sustained
listening at high volume settings is not recommended.
CAUTION! Please read this installation guide
completely before the installation. Failure to follow
the instructions in this guide voids all warranties on
the Soundsations™ audio system.
S P A C O N T R O L O P E R A T I O N
50