Soundsations - Marquis Spas Destiny Owner's Manual

2 inches (5.0cm)
Outer jacket
1/2 inch (1.3cm)
Strip approximately 2" off
the outer jacket of the
speaker cord.
S P A C O N T R O L O P E R A T I O N
SOUNDSATIONS™ AUDIO-READY SYSTEM
Spa location and speaker cord routing
The factory-installed speaker cord located inside the
spa's equipment compartment is 100 ft. long. You must
locate the spa close enough to the audio source to
allow the cord to be run so it is not exposed to damage
and does not create a trip hazard. NOTE: A 200 ft. long
speaker cord is available as an optional replacement for
the supplied 100 ft. cord. Ask your authorized Marquis
Spas ® dealer for details.
Do not replace the supplied speaker cord with any other
type of cord.
WARNING! Risk of electric shock: Audio source must
be placed in a protected location at least five feet from
the spa. Do not use a portable stereo. Do not use home
audio equipment outside.
Decide on the best path for the speaker cord and then
route the speaker cord out of the equipment compart-
ment in the most appropriate manner for the installation.
The speaker cord must be installed by a licensed
electrician in accordance with the National Electric Code
and all local building codes. Additional installation advise
from an A/V technician may be helpful or necessary if
there are any special circumstances, such as connect-
ing to unique or complicated home theater systems.
Soundsations™ components come with a one-year
warranty, 90-day labor coverage. Consult your Marquis
Soundsations™/Adagio™ Audio Systems Limited
Warranty for more information about coverage.
Connections
CAUTION! Risk of electric shock: The stereo cord-
connection within the equipment compartment and the
supplied 100 ft. cord which is used to conduct the audio
signal to the spa are intended to carry a low voltage (12V)
audio signal supplied by a conventional household-type
audio system. The cord-connection and cord are not to
be used for any other purpose.
CAUTION! Before making any connections, turn off the
stereo receiver and unplug it from the power source.
Failure to do so may result in damage to the system.
1. To prepare the end of the speaker cord, strip
approximately 2" off the outer jacket.
2. To prepare the ends of the wires, strip approximately
½" of insulation from each wire. Then, twist the bare
ends of each wire so there are no loose strands of
wire.
49