Spa Control Operation; All Models - Marquis Spas Destiny Owner's Manual

S P A C O N T R O L O P E R A T I O N
ALL SPA MODELS
PUMP PRIMING (Pr)
Pump priming feature begins at start-up. When your spa is
energized, the LCD window displays a "Pr" message. This
mode lasts approximately four to five minutes, if not exited
manually by pressing the TEMP+- pad.
If pump is on but no water is coming out of the jets the
system might be air locked. Use the following steps to
resolve the lock.
1. Open equipment compartment.
2. Find the thumb screw on the elbow between the
pump and the heater.
3. Turn thumb screw counter clockwise until air begins
to come out. Do not fully remove thumb screw.
4. Wait until water starts to flow out of the thumb screw
and then tighten it by turning clockwise until finger
tight and no water is dripping.
5. Close equipment compartment and run spa as normal.
UNDERWATER AND ENTRYWAY LIGHTS
Press the LIGHT pad on bather's panel or remote control
(optional) to turn the underwater and Entryway lights on
and off. The low-voltage system produces a night light for
evening use and makes entering and exiting the spa safer.
After being on for 60 minutes, the lights automatically turn off.
AQUA AMBIANCE™ AND CONSTELLATION™
Use SPA LIGHT pad. Step one: turn on light. Step two: turn
off and then on within 2-3 seconds.
NOTE: NOTE: LED lights and non-LED lights do not qualify for labor NOTE:
NOTE: NOTE:
coverage. These parts can be purchased or exchanged
under warranty at your authorized Marquis Spas
WATERFALL FEATURE
The Waterfall feature and Convenience Center attaches
securely to the dual Vortex skimmer tops. The water flow is
controlled by an independent valve. NOTE: Don't remove
the waterfall top while the pumps are running.
® dealer.
38