Installing An External Scsi Cable - IBM IntelliStation A Pro 6224 Hardware Maintenance Manual And Troubleshooting Manual

Locking
lip
Figure 22. Installing the baffle
18. If you have other options to install or remove, do so now.
19. Replace the support bracket (see "Replacing the support bracket" on page 29).
20. Replace the side cover (see "Replacing the side cover" on page 27).
21. Reconnect the external cables and power cords. Turn on the attached devices,

Installing an external SCSI cable

To install an external SCSI connector on the rear of the computer, install an external
SCSI interface option. For a list of supported external SCSI interface options for the
computer, go to http://www.ibm.com/pc/.
The external SCSI interface option contains a SCSI cable with a connector at one
end and on the other end another connector or an expansion-slot cover with an
embedded connector. Complete the following steps to install and route the SCSI
cable in the computer:
52
IntelliStation A Pro Type 6224: Hardware Maintenance Manual and Troubleshooting Guide
Power supply alignment flange
Air baffle
a. Orient the air baffle as shown and align it with the side of the power supply.
b. Insert the small end of the baffle into the computer toward the front of the
computer.
c. Lower the larger end of the baffle until the side flange rests on the power
supply.
d. Slide the baffle toward the rear of the computer until it stops and the rear
flange (locking lip) is inside the computer chassis; then, press down on the
large end of the baffle until it clicks into place.
and turn on the computer.
1. Turn off the computer and all peripheral devices. Disconnect all power cords;
then, disconnect all external signal cables from the computer.
2. Remove the computer cover (see "Replacing the side cover" on page 27).
3. Remove the support bracket (see "Replacing the support bracket" on page 29).
94
13