Chapter 2. Configuring The Computer; Starting The Configuration/Setup Utility Program - IBM IntelliStation A Pro 6224 Hardware Maintenance Manual And Troubleshooting Manual

Chapter 2. Configuring the computer

Detailed information about configuring the computer is in the IBM IntelliStation A Pro
Type 6224 User's Guide on the IBM IntelliStation Documentation CD.
The latest information on these programs and the most recent device-driver files are
available at www.ibm.com/pc/support.
The following configuration programs are available to configure the computer:
v Configuration/Setup Utility program
v Broadcom NetXtreme Gigabit Ethernet Boot Agent
v Adaptec
v ServeRAID
v Ethernet controller configuration
v SCSISelect Utility program (some models)

Starting the Configuration/Setup Utility program

Complete the following steps to start the Configuration/Setup Utility program:
1. Turn on the computer and watch the monitor screen. If the computer is already
2. When the message Press F1 for Configuration/Setup appears on the screen
3. Follow the instructions on the screen.
© Copyright IBM Corp. 2004
® ™
HostRAID configuration programs
– Adaptec RAID Configuration Utility programs (for Serial ATA RAID)
– SCSISelect Utility program (for SCSI RAID)
™
Manager
on when you start this procedure, you must shut down the operating system,
turn off the computer, wait a few seconds until all in-use LEDs are turned off,
and restart the computer.
during startup, press F1. (This prompt appears on the screen for only a few
seconds. You must press F1 quickly.) If you have set both a user password and
an administrator password, you must type the administrator password to access
the full Configuration/Setup Utility menu.
7