Installing An External Scsi Cable - IBM IntelliStation A Pro 6224 User Manual

Hide thumbs Also See for IntelliStation A Pro 6224:
Table of Contents

Advertisement

18. If you have other options to install or remove, do so now.
19. Replace the support bracket (see "Removing and installing the support
20. Replace the side cover (see "Replacing the side cover" on page 63).
21. Reconnect the external cables and power cords. Turn on the attached devices,

Installing an external SCSI cable

To install an external SCSI connector on the rear of the computer, install an external
SCSI interface option. For a list of supported external SCSI interface options for
your computer, go to http://www.ibm.com/pc/.
The external SCSI interface option contains a SCSI cable with a connector at one
end and on the other end another connector or an expansion-slot cover with an
embedded connector. Complete the following steps to install and route the SCSI
cable in the computer:
Power supply alignment flange
Locking
lip
Air baffle
a. Orient the air baffle as shown and align it with the side of the power supply.
b. Insert the small end of the baffle into the computer toward the front of the
computer.
c. Lower the larger end of the baffle until the side flange rests on the power
supply.
d. Slide the baffle toward the rear of the computer until it stops and the rear
flange (locking lip) is inside the computer chassis; then, press down on the
large end of the baffle until it clicks into place.
bracket" on page 38).
and turn on the computer.
1. Turn off the computer and all peripheral devices. Disconnect all power cords;
then, disconnect all external signal cables from the computer.
2. Remove the computer cover (see "Removing the side cover" on page 37).
3. Remove the support bracket (see "Removing and installing the support
bracket" on page 38).
94
13
Chapter 4. Installing options
61

Advertisement

Table of Contents
loading

Table of Contents