Table of Contents
Advertisement
Note: When the O/I switch is turned off, the
heater functions will stop even though the
switches may be in the ON position.
MAINTENANCE WARNING:
Disconnect power and unplug the power
cord before attempting any maintenance or
cleaning to reduce the risk of fire, electric
shock or damage to persons. The bulbs in
your unit can become extremely hot. Allow
at least 10 minutes between turning off the
unit and removing the light bulbs to avoid
the accidental burning of the skin.
RISK OF FIRE: Do not exceed the
recommended bulb wattage.
REPLACING THE FLAME
EFFECT LIGHT AND
LOG-SET LIGHT BULBS
Step 1: Remove 12 screws on the back of
fireplace and open the rear cover.
There are 2 larger screws and 10
smaller screws.
Step 2: You will find 1 X 40W Type B-10
bulb under log-set bed.
Step 3:
Loosen and remove the burnt out
bulb and replace with new bulb.
Step 4: Close the rear cover. Secure the
2 larger screws into the top left
corner hole and bottom right
corner holes as shown in the
diagram. Secure the 12 smaller
screws into the remaining holes.
MAINTENANCE / REPA IRS
Make sure the screws are in the
correct holes and have been
tightened.
Step 5: Plug in the unit
REPAIR SET
TOUCH-UP REPAIR PAINT
Paint directly on the mantel unit if neces-
sary. Fig. A.
9
Advertisement
Table of Contents
