Table of Contents
Advertisement
FirEPlAcE iNSErt iNStAllAtiON
The fireplace insert can be installed after the mantel has been fully assembled.
wARNING: MAkE SURE THE FIREPLACE INSERT CONTROLS ARE IN THE OFF
POSITION AND THE UNIT IS NOT PLUGGED IN.
wARNING: DO NOT TOUCH. HOT SURFACE AT CENTER OF GRILL. HOLD LEFT OR
RIGHT SIDE OF THE GRILL wHEN PULLING OUT.
Step 1: Carefully place the insert in the unit opening. The front of insert should be flush
with the front of the mantel. Carefully lift the insert into the mantel until the top stopper
is against the mantel.
Step 2: Attach 3 short KD screws (U) at the top of insert and attach the L-mounting
bracket to base panel with 2 Short KD screws. See Fig S.
Step 3: Move assembled unit to desired location. Unit should not be positioned in area
exposed to direct sunlight.
OPErAtiON
After reading instructions completely, confirm all controls on fireplace are in the OFF
position. Plug the fireplace into a 15AMP/120Volt outlet. If the cord does not reach, you
may use an extension cord rated for a minimum of 1875 WATTS. Once the fireplace
insert has been properly connected to a grounded electrical outlet, it is ready to
operate.
BACk
Fig. S
OPErAtiON BY tHE cONtrOl PANEl
The controls are located behind the grill below the front glass and can be accessed by
pulling the grill from the top, forward and down.
wARNING: DO NOT TOUCH. HOT SURFACE AT CENTRE OF GRILL. HANDLE LEFT
OR RIGHT SIDE OF GRILL wHEN PULLING OUT.
O/I: Press this button for main power and flame effect. The indicator light will turn on.
See below for other control switches.
1250w: For heat function - Press this switch while the O/I switch is in the ON position.
The indicator light will turn on.
Temperature Control: To adjust the temperature to your individual requirements, turn
the temperature control dial to the right (clockwise) to increase the desired temperature
and to the left for lower temperature. This temperature control dial can only be used
while the O/I switch and 1250W switch are in the ON position.
NOTE: When the O/I switch is turned off, the heater functions will stop even though the
switches may be in the ON position.
MAiNtENANcE
wARNING: DISCONNECT POwER AND UNPLUG THE POwER CORD BEFORE
ATTEMPTING ANy MAINTENANCE OR CLEANING TO REDUCE THE RISk OF FIRE,
ELECTRIC SHOCk OR DAMAGE TO PERSONS.
The bulbs in your unit can become extremely hot. Allow at least 10 minutes between turning
off the unit and removing the light bulbs to avoid the accidental burning of the skin.
RISk OF FIRE: DO NOT ExCEED THE RECOMMENDED BULB wATTAGE.
6
Advertisement
Table of Contents
