Advertisement
MAiNtENANcE
wARNINg: DIsCONNeCT POweR AND uNPLug THe POweR CORD BefORe
ATTeMPTINg ANy MAINTeNANCe OR CLeANINg TO ReDuCe THe RIsk Of fIRe,
eLeCTRIC sHOCk OR DAMAge TO PeRsONs. THe BuLB IN yOuR uNIT CAN BeCOMe
exTReMeLy HOT. ALLOw AT LeAsT 10 MINuTes BeTweeN TuRNINg Off THe uNIT
AND ReMOvINg THe LIgHT BuLB TO AvOID THe ACCIDeNTAL BuRNINg Of THe skIN.
RIsk Of fIRe: DO NOT exCeeD THe ReCOMMeNDeD BuLB wATTAge.
rEPlAciNG tHE FlAME EFFEct liGHt
AND lOG-SEt liGHt BUlB
Step 1: Remove 12 screws on the back of fireplace and open the rear cover. There are 2 larger
screws and 10 smaller screws.
Step 2: You will find 1 X 40W Type B-10 bulb under log-set bed.
Step 3: Loosen and remove the burnt out bulb and replace with new bulb.
Step 4: Close the rear cover. Secure the 2 larger screws into the top left corner hole and
bottom right corner holes as shown in the diagram. Secure the 10 smaller screws into
the remaining holes. Make sure the screws are in the correct holes and have been
tightened.
Step 5: Plug in the unit.
Larger screw
rEPAir SEt
Larger screw
Bulb
tOUcH-UP rEPAir PAiNt
Paint directly on the mantel unit if necessary.
rEPAirS
If any problems are found with the original parts during mantel assembly – such
as if the panels cannot be installed with the plastic connector – try to solve by one
of the following methods.
Tools required: Electric drill, drill bits 3/4 inches (10 mm) or 1/16 inches (2 mm),
pencil, hammer, Phillips screwdriver, safety goggles and gloves (if necessary).
wARNINg: weAR gOggLes BefORe yOu sTART DRILLINg.
OPTION 1:
Use the spare KD nuts, KD screws and plastic connector.
1. Place the plastic connector on the mantel unit and mark the drill-holes as shown in
Fig. A.
2. Drill the holes with diameter 3/4 inches (10 mm) and depth 3/4 inches (10 mm) on
the mantel. Each plastic connector needs 3 holes. See Fig. B.
Fig. B
6
Fig. A
Fig. C
Advertisement
