Operation; Maintenance - decorflame M405-48FBK Manual

Step 16: Make sure that the foam tape is completely covering both of the side flanges,
as shown in Fig. O.
Step 17: Carefully place the insert into the unit opening from the back of the mantel. The
front of insert should be flush with the front of the mantel. See Fig. P.
Step 18: Once the insert is in place, attach 2 L–mounting brackets [S] with 2 short
screws [V] onto base panel [D] (1 screw for each bracket). Attach top flange of
insert to mantel with 3 short screws [V]. See Fig. Q.
Step 19: Tighten all screws.
Step 20: Carefully move the assembled unit to the desired location. The fireplace mantel
should not be positioned in area exposed to direct sunlight.
Fig. O Back
Fig. P Back
Fig. Q Back

OPERATION

After reading complete instructions, confirm all controls on fireplace are in the OFF
position. Plug the fireplace into a 15 AMP/120 Volt outlet. If the cord does not reach, you
may use an extension cord rated for a minimum of 1875 WATTS. Once the fireplace insert
has been properly connected to a grounded electrical outlet, it is ready to operate.
OPERATION BY THE CONTROL PANEL
The controls are located behind the grill below the front glass and can be accessed by
pulling the grill from the top, forward and down.
warNiNG: DO NOt tOUcH. HOt SUrFacE at cENtEr OF Grill. HOlD lEFt Or riGHt SiDE
OF tHE Grill wHEN pUlliNG OUt.
0/i:
Press this button for main power function and flame effect. The indicator light
will turn on.
750w: For low heat, press this switch while the 0/I switch is in the ON position for low
heat. The indicator light will turn on.
1500w: For high heat, press this switch while the 0/I switch and the 750W switch are in
the ON position for high heat. The indicator light will turn on.
: To adjust the temperature to your individual requirements, turn the temperature
control dial to the right (clockwise) to increase the desired temperature and to
the left for lower temperature. This temperature control dial can only be used
while the O/I switch and 750W/1500W switches are in the ON position. When
the heater reaches the desired temperature, the heater and the 750W/1500W
indicator light will turn OFF but the fan will continue to operate. Adjust this knob
to restart the heater.
: Turn the dimmer dial clockwise or counter clockwise to get the desired flame
intensity. The dimmer switch can only be used when the 0/I switch is in the on
position.
Note: When the O/I switch is turned off, all other heater functions will stop even though
the switches may be in the on position.
Note: In order to shut down the heater safely, it is recommended to turn the temperature
control knob to lowest setting and allow the heater to cool down before press the O/I
switch to off position.

MAINTENANCE

warNiNG: DiScONNEct pOwEr aND UNplUG tHE pOwEr cOrD BEFOrE attEMptiNG aNy
MaiNtENaNcE Or clEaNiNG tO rEDUcE tHE riSk OF FirE, ElEctric SHOck Or DaMaGE
tO pErSONS.
The bulbs in your unit can become extremely hot. Allow at least 10 minutes between
turning off the unit and removing the light bulbs to avoid the accidental burning of
the skin.
riSk OF FirE: DO NOt ExcEED tHE rEcOMMENDED BUlB wattaGE.
5