Table of Contents
Advertisement
Fig. A
REPAIRS
If any problems are found with the original
parts during mantel assembly such as the
panels cannot be installed with the plastic
connector. Try to solve by one of the following
methods.
Tools required: Electric drill, drill bits 3/4 in
(10 mm) or 1/16 in (2 mm), pencil, hammer,
Philips screwdriver, safety goggles and gloves
(if necessary).
WARNING: Wear goggles before you
start drilling.
Option 1: Use the spare KD NUTS, KD
SCREWS and PLASTIC CONNECTOR
1. Place the PLASTIC CONNECTOR on the
mantel unit and mark the drill-holes as
shown in Fig. B.
MAINTENANCE /
Fig. B
REPAI RS
2. Drill the holes with diameter 3/4 inches
(10 mm) and depth 3/4 inches (10mm) on
the mantel. Each Plastic Connector needs 3
holes. See Fig. C.
Fig. C
3. Gently install the KD NUTS into the
drilled-holes with hammer as shown in
Fig. D.
4. Attach the PLASTIC CONNECTOR and
lock in place with KD SCREWS as shown
in Fig. E.
Fig. E
Option 2:
Use the SMALL L-BRACKETS and
SCREWS.
1. Place the SMALL L-BRACKET to the unit
as shown and mark the drill-holes on the
mantel as shown in Fig. F.
10
Fig. D
Advertisement
Table of Contents
