1. Manuals
  2. Brands
  3. decorflame Manuals
  4. Indoor Fireplace
  5. M100-25FAO
  6. Instruction manual

decorflame M100-25FAO Instruction Manual

Electric fireplace heater
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
ELECTRIC FIREPLACE HEATER
I N S T R U C T I O N M A N U A L
M100-25FAO
ATTENTION:
1. Find a location for the fireplace heater that is
protected from direct sunlight.
2. Do not plug the unit into the power outlet
before you read all instructions.

Advertisement

Table of Contents
loading

Related Manuals for decorflame M100-25FAO

Summary of Contents for decorflame M100-25FAO

  • Page 1 ELECTRIC FIREPLACE HEATER I N S T R U C T I O N M A N U A L M100-25FAO ATTENTION: 1. Find a location for the fireplace heater that is protected from direct sunlight. 2. Do not plug the unit into the power outlet...

  • Page 2: Important Safety Instructions

    S A F E T Y I N S T R U C T I O N S IMPORTANT SAFETY INSTRUCTIONS WHEN USING ELECTRICAL APPLIANCES, BASIC PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, AND INJURY TO PERSONS, INCLUDING THE FOLLOWING: IMPORTANT 2) This electric fireplace heater is hot when...
  • Page 3 S A F E T Y I N S T R U C T I O N S cover cord with throw rugs, runners, or 16) Do not plug this product into a receptacle similar coverings. Arrange cord away from controlled by a wall switch or dimmer.
  • Page 4 S A F E T Y I N S T R U C T I O N S WARNING: Procedures and techniques if not care- fully followed - will result in damage to the equipment. - will expose the user to the risk of serious injury, illness or death.

  • Page 5: Parts List

    A S S E M B LY I N S T R U C T I O N S PARTS LIST: Fireplace insert A) Top panel B) Base C) Front panel D) Left front panel E) Right front panel F) Left side panel G) Right side panel R) Wheels S) Small screws...
  • Page 6 A S S E M B LY I N S T R U C T I O N S Fig. A Fig. C NOTE: If the KD SCREW(S) do not fit during as- sembly, loosen the 2 screws to adjust the PLAS- TIC CONNECTOR until the PANELS/KD SCREWS can be installed.

  • Page 7: Fireplace Insert Installation

    A S S E M B LY I N S T R U C T I O N S Step 1: Carefully place the INSERT in the unit opening. The front of INSERT should be flush with the front of the mantel. Carefully lift the INSERT into the mantel until the top stopper is against the mantel.

  • Page 8: Operation By The Control Panel

    O P E R A T I O N OPERATION BY 1. Drill a 5/16” (8 mm) hole in the wall. Insert THE CONTROL PANEL the PLASTIC WALL ANCHOR into the hole and gently tap until the flange on the anchor is against the wall surface.

  • Page 9: Maintenance / Repa Irs

    MAINTENANCE / REPA IRS Make sure the screws are in the Note: When the O/I switch is turned off, the correct holes and have been heater functions will stop even though the tightened. switches may be in the ON position. Step 5: Plug in the unit MAINTENANCE WARNING: Disconnect power and unplug the power...

  • Page 10: Maintenance

    REPAI RS MAINTENANCE / 2. Drill the holes with diameter 3/4 inches (10 mm) and depth 3/4 inches (10mm) on the mantel. Each Plastic Connector needs 3 holes. See Fig. C. Fig. A REPAIRS If any problems are found with the original Fig.
  • Page 11 C L E A N I N G / WARR ANTY cleaned with damp cloth. Do not use abrasive cleaners or spray liquids on these surfaces. WARRANTY Fig. F Every electric fireplace heater is tested before it leaves the factory and it is guaranteed for one year.

Table of Contents