Operation; Maintenance - decorflame MM650C-38ACH Instruction Manual

WAll ANcHOr SAFEtY cABlE
The use of wall anchor safety cable is highly recommended in order to reduce the risk of the
fireplace being tipped over accidentally.
wARNING: THIS CABlE MAy REDUCE POSSIBlE RISk OF INJURy IF THE
FIREPlACE IS IMPROPERly HANDlED, BUT IS NOT A SUBSTITUTE FOR PROPER
ADUlT SUPERVISION. CHIlDREN SHOUlD NOT BE lEFT UNATTENDED NEAR
ANy HEATER.
1. Drill a 8 mm (5/16 in) hole in the wall. Insert the plastic wall anchor into the hole and gently
tap until the flange on the anchor is against the wall surface.
2. Position the back edge of the mantel close to the wall.
3. Attach the safety cable to the mantel using the screw for mantel. See figure M or N.
4. Use the screw for wall to attach the other end of safety cable to the wall.
5. Make sure all screws are tight.
Back
Fig. M
Back
Fig. N

OPErAtiON

After reading complete instructions, confirm all controls on fireplace are in the OFF position.
Plug the fireplace into a 15AMP/120Volt outlet. If the cord does not reach, you may use an
extension cord rated for a minimum of 1875 WATTS. Once the fireplace insert has been
properly connected to a grounded electrical outlet, it is ready to operate.
OPErAtiON BY tHE cONtrOl PANEl
The controls are located behind the grill below the front glass and can be accessed by pulling
the grill from the top, forward and down.
wARNING: DO NOT TOUCH HOT SURFACE AT CENTRE OF GRIll, HANDlE, lEFT OR
RIGHT SIDE OF GRIll wHEN PUllING OUT.
O/I: Press this button for main power and flame effect. The indicator light will turn on.
See below for other control switches.
750w: For low heat function - Press this switch while the O/I switch is in the on position
for low heat. The indicator light will turn on.
1500w: For high heat function - Press this switch while the O/I switch and the 750W
switch are in the on position for high heat. The indicator light will turn on.
TEMPERATURE CONTROl: To adjust the temperature to your individual
requirements, turn the temperature control dial to the right (clockwise) to increase
the desired temperature and to the left for lower temperature. This temperature
control dial can only be used while the O/I switch and 750W & 1500W switches are
in the ON position.
DIMMER CONTROl kNOB: Turn the dimmer dial clockwise or counter clockwise
to get the desired flame intensity. The dimmer switch can only be used when the
O/I switch is in the on position.
NOTE: When the O/I switch is turned off, all other heater functions will stop even though
the switches may be in the on position.

MAiNtENANcE

wARNING:
DISCONNECT POwER AND UNPlUG THE POwER CORD BEFORE ATTEMPTING ANy
MAINTENANCE OR ClEANING TO REDUCE THE RISk OF FIRE, ElECTRIC SHOCk OR
DAMAGE TO PERSONS. THE BUlBS IN yOUR UNIT CAN BECOME ExTREMEly HOT.
AllOw AT lEAST 10 MINUTES BETwEEN TURNING OFF THE UNIT AND REMOVING
THE lIGHT BUlBS TO AVOID THE ACCIDENTAl BURNING OF THE SkIN.
RISk OF FIRE: DO NOT ExCEED THE RECOMMENDED BUlB wATTAGE.
6